Euro2 or Euro3

[kaldis12]

Thanks for the info Just gathering some information for my new engine build It will be propably a d50b engine. What's your opinion about d50b engines? Are they good, or the older ebs was better?

[toratora]

I've only played around with one Euro3, but it seems to be similar in many ways. Similar enough that I would't worry either way. Find the kit that you want to run, and make your decision based on that kit.

Bidalot just set the 50cc, and 100cc land speed record with a Derbi Euro3 engineso it must be pretty decent.

[kaldis12]

I just can't really find a cheaper 52mm bore kit. 2fast is the only one i saw. As for am6 there is the italkit 94.

[toratora]

I haven't really looked for kits bigger than the 88cc kits for the Euro2 engines. When looking for a setup for the Euro3 there were a couple of places that I found very interesting. TRT 2Fast was very friendly to me, and supported me quite well. I'm very happy with their products. If they made stuff for the Euro2 then I would probably get more from them. For now though I only have one Euro3 bike, and I bought everything they had for it.

[kaldis12]

Yeah I seen it that for the Euro2 engines there is not really a good bigger kits, maybe I will try out the Euro3 D50b tuning. Just interested in this engine Is it rattling hardly? If I know it right there is no balnce shaft on the d50b.

[toratora]

The MSX 90cc kit is available for Euro2.

[kaldis12]

Ooh I didn't seee thaat!